#Osculator templates for logic install#

Quantitatively the dephased oscillations of the components of the network. Implementation of nucleobase quenching to monitor a DNA-based chemical oscillator, allowing us to follow in real time and Relatively non-invasive and compatible with the complex dynamics of DNA reaction circuits. Compared with other sequence-specific detection methods, it is Presents a high sensitivity even for small oligonucleotides. Quenching by nucleobases provides a highly sequence-specific monitoring technique, which Nucleotides, it is possible to obtain opposite changes in fluorescence intensity for oligonucleotides whose hybridization Depending on the nature of theįluorophore's nearest base pair, fluorescence intensity is decreased or increased upon hybridization. Modulated by the interaction of the 3′-terminus fluorophore with the nucleobases themselves. In this quencher-free setup, the signal is On the labeling of DNA oligonucleotides with a single fluorescent modification. Note that I haven't tried this.We present a simple yet efficient technique to monitor the dynamics of DNA-based reaction circuits. Just have Osculator send the same messages and Logic will think that device is really there. Or something simpler like a Frontier Tranzport. So the point is that you may be able to have Osculator emulate an MC to some degree. Logic then sends an appropriate note message that toggles the transport lights on the MC.

If you look at the play command in the assignments, and load up MIDI Monitor, you'll see that the MC sends and receives note messages to control Logic's transport.

#Osculator templates for logic install#

In the Control Surface Setup, install a Mackie Control and set its in and out ports to Osculator. Since I have several supported devices, I don't have much need for messing with controller assignments, but there is something you can try. Much of the controlling logic for supported control surfaces happens behind the scenes. It must be sending *something* for Mackie Control-type devices to work. I don't touch my computer keyboard anymore when recording, and it only took me a couple of hours to create just the interface I needed.Īlso, is there a way to monitor what messages Logic sends when using the Transport Bar (Play, Cycle, Stop etc). Some control apps do that (ProRemote.) but I don't know how. I must have been kidding myselfĪlso, I can't get the kind of shuttle control you get with Mackie Control hardware by using keyboard shortcuts (you only get 'shuttle left' and 'shuttle right', can't be done with a two-way fader with travel distance controlling shuttle speed).

That's why I was curious if there was some 'universal' way of sending out commands. But because OSCulator can't send any function key above F16 I had to change that. I didn't say TouchOSC could receive OSC commands, I'm just discovering the possibilities and was wondering if a two-way toggle switch was one of them.Īn example for changing key commands: for a long while I had Left/Right Locators 'set' and ''go to' commands assigned to F16-F19, right above the numeric pad which I use for most transport commands.